NEW Freehander Replacement Kit

$23

Item: # 30-001564

With regular use and exposure to the elements, it is inevitable that certain parts of any tool will need a refresh. Extend the life of your line management tool with the Freehander Replacement Kit, equipped with cutter and Respike™ replacement parts.

Details:

Exchangeable cutters
Exchangeable + multi-positional respike™

FASTENER REPLACEMENT

Use Torx T6 wrench to remove Respike™ & standard fastenerfrom target location. *Respike™fastener is sharp & may cause injury if user is not careful. Avoid contact w/ pin tip during removal & re-installation.
Re-insert Respike™ & standard fastener into new desired locations. Use a small amount of removable thread locker. Do not overtighten. *Align cutter teeth if necessary. See pg. 06 for instructions.
Do not adjust line vise or axle screws.

TEETH ALIGNMENT

Using a Torx T6 wrench, slightly loosen the fasteners on the slot side until the cutters can slide freely.
Place nippers face down on a flat horizontal surface & gently squeeze jaws together until teeth just touch.
Carefully tighten slot side fasteners while still face down. Do not overtighten. Check teeth alignment. Go back to step on if not sufficiently aligned.

Download Instructions here.

SUPERVISE TECH™

A caught line isn't a benefit - unless it's caught in the patented retention clip of the FreeHander. Featuring Supervise Tech™, the pivoting clip holds line for steady one-hand operation when cutting and securing line.