close email sign-up pop-up
SLEIGH THE SHOPPING LIST // SHOP THE BADASS GIFT GUIDE
GerberGear
Gerber Magniplier Replacement Kit
Gerber Magniplier Replacement Kit

NEW Magniplier Tip Fastener Replacement Kit

  •  
$23
Item: # 30-001566

With regular use and exposure to the elements, it is inevitable that certain parts of any tool will need a refresh. Extend the life of your pliers with the Magniplier Replacement Kit, equipped with tip fastener replacement parts.

Currently Out of Stock

QUESTIONS? Contact Gerber

Details:

    • Exchangeable jaw tips w/ outboard fasteners
  • Warranty

Additional Versions:

Tip Fastener Replacement

  • Apply removable strength thread locker to the male threads of all tip fasteners. *Not required but recommended.
  • Position the tips into place on the free handle & lock handle. Install 2 tip fasteners onto each tip but do not completely tighten so the tips can move freely.
  • There are two lengths of tip fasteners:
    • a. Short tip fastener [M3X0.5X6MM]
    • b. Long tip fastener [M3X0.5X9MM]
  • Align each tip [side to side & front to back]. Push the end of both tips towards the hub to ensure they are both correctly “set”. *Align tips side to side and front to back, squeeze together & tighten fasteners, then torque.
  • Tighten the lock handle tip fasteners in the sequence below:
    • a. Secure the short tip fastener. Torque to 10.0 KG-CM [8.67 LB-IN]. *Careful not to over torque & strip the head of the fastener.
    • b. Secure the long tip fastener. Torque to 10.0 KG-CM [8.67 LB-IN]. *Careful not to over torque & strip the head of the fastener.
  • 6. Tighten the free handle tip fasteners in the sequence below:
    • a. Secure the short tip fastener. Torque to 10.0 KG-CM [8.67 LB-IN]. *Careful not to over torque & strip the head of the fastener.
    • b. Secure the long tip fastener. Torque to 10.0 KG-CM [8.67 LB-IN]. *Careful not to over torque & strip the head of the fastener.
  • 7. Reverify the cutter gap:
    • a. Lightly squeeze the handles; confirm there is no gap between the cutting & anvil edge contact point.
  • 8. Once finished, there should be no gap along cutters when handles are closed and a small gap at tip end when handles are closed. *There will be a small tip gap present to allow for the carbide cutters to touch first.

Download instructions here.

Technology Image

CRUSH IT

Not all pliers are created equal, some are just overachievers. The Magnipliers are optimized for swift power with BearHand Control™, an ergonomic control system: optimized space between handles, off axis shape for line of sight, and a finger choil that mimics a trigger grip.

  1. Exchangeable jaw tips w/ outboard fasteners
  2. Exchangeable/reversible carbide cutters
  3. Plunge lock
  4. Angled shape/off axis
  5. Tether point to secure [lanyard included]
  6. Optimized space between handles for maximum control
  7. Finger choil
You Might Also Like
Reviews
Write A Review
Give us your opinion
Please, fill all fields.
Too long review. Limit is 1023 characters.

Thank You

Thank You. Your review will be displayed after it is accepted. Note: Reviews are only moderated for foul language and negative interactions among reviewers.