close email sign-up pop-up
SLEIGH THE SHOPPING LIST // SHOP THE BADASS GIFT GUIDE
GerberGear
Gerber Freehander Replacement Kit
Gerber Freehander Replacement Kit

NEW Freehander Replacement Kit

  •  
$18
Item: # 30-001564

With regular use and exposure to the elements, it is inevitable that certain parts of any tool will need a refresh. Extend the life of your line management tool with the Freehander Replacement Kit, equipped with cutter and Respike™ replacement parts.

Currently Out of Stock

QUESTIONS? Contact Gerber

Details:

    • Exchangeable cutters
    • Exchangeable + multi-positional respike™
  • Warranty

FASTENER REPLACEMENT

  • Use Torx T6 wrench to remove Respike™ & standard fastenerfrom target location. *Respike™fastener is sharp & may cause injury if user is not careful. Avoid contact w/ pin tip during removal & re-installation.
  • Re-insert Respike™ & standard fastener into new desired locations. Use a small amount of removable thread locker. Do not overtighten. *Align cutter teeth if necessary. See pg. 06 for instructions.
  • Do not adjust line vise or axle screws.

TEETH ALIGNMENT

  • Using a Torx T6 wrench, slightly loosen the fasteners on the slot side until the cutters can slide freely.
  • Place nippers face down on a flat horizontal surface & gently squeeze jaws together until teeth just touch.
  • Carefully tighten slot side fasteners while still face down. Do not overtighten. Check teeth alignment. Go back to step on if not sufficiently aligned.

Download Instructions here.

Technology Image

SUPERVISE TECH™

A caught line isn't a benefit - unless it's caught in the patented retention clip of the FreeHander. Featuring Supervise Tech™, the pivoting clip holds line for steady one-hand operation when cutting and securing line.

  1. Exchangeable cutters
  2. Exchangeable + multi-positional respike™
  3. SuperVise Tech™ pivoting line vise
  4. Tether point
  5.  Wide paddle for maximum contact and control
You Might Also Like
Reviews
Write A Review
Give us your opinion
Please, fill all fields.
Too long review. Limit is 1023 characters.

Thank You

Thank You. Your review will be displayed after it is accepted. Note: Reviews are only moderated for foul language and negative interactions among reviewers.